Composite Material Storage and Shelf-Life Records
How material batches, cumulative exposure and supplier storage instructions connect to an individual composite build record.
GAUTEN UAV / TOPIC ARCHIVE
Author: GAUTEN UAV
AOKE UAV publishing account.
Printed Cooling Duct Prototypes: Fit Is Only the Beginning
A duct mockup can resolve bay interference while leaving airflow, temperature, retention, and installed cooling performance unproven.
Nonstructural Radomes: Separate RF and Mechanical Requirements
How to separate antenna-cover attachment evidence from unverified radio-transmission claims on a large UAV.
Avionics Power Is Not the Same Question as Propulsion Power
A propulsion energy budget does not establish the regulated supply paths needed by flight-controller electronics and other avionics consumers.
Construction Progress Imagery Versus Verified Measurement
A dated construction overview is useful evidence, but quantities and completion claims require their own measurement definitions and acceptance records.
LiDAR Scan Geometry in Fixed-Wing Integration
A bounded center-to-edge comparison shows how range, incidence and aircraft roll change LiDAR intersections and the useful swath in fixed-wing integration.
Printed Support Tools for an Approved Composite Repair
A custom printed support may assist an authorized composite repair, but its geometry and material must remain subordinate to the repair instructions.
Repeated Hatch Access and Composite Fastener Wear
How hatch attachment records connect frequent bay access with local composite inspection and hardware history.
Servo Power Planning for Large Fixed-Wing Controls
Wing actuators need a documented electrical supply independent of assumptions about the flight controller, with evidence for simultaneous loads and wiring interfaces.
Repeat Stockpile Monitoring and Comparable Surfaces
Repeat stockpile results need comparable boundaries, base definitions and reference evidence before a volume difference can be interpreted as material movement.